Basics
Documentation
Examples
User Tools
Sidebar
getting_started
This is an old revision of the document!
Getting started
Xraytrace is run from console, using a parameter file as argument. Parameter file is a plain text file with some commands (described in the other sections of this documentation) and with links to other files.
A very minimum set needed for a reasonable calculation is shown here. It consist of three files: parameter file, sample geometry definition file and table of material parameters.
test.par:
test.mat:
test.table:
getting_started.1516826408.txt.gz · Last modified: 2018/01/24 21:40 by pklapetek
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
