Xraytrace documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

===== Material parameters =====


The materials used within the calculation are represented by materials table, which is
supplied as a an input file, defined at the same moment as the data are loaded (see the [[computational_domain|computational domain]] section).

This file has a simple structure - a set of entries for individual material indices,
defining how the system should get the material data. Each row starts by material index (to match
the indices in the VTK file or vector file defining the [[sample_geometry|sample geometry)]].
Then, material type is listed (0 for direct definition of n, k, density and attenuation, 99 for use of the xraylib database). For material type equal to 0 the further four values are real and imaginary part of the refractive index, density (in g/cm3) and attenuation coefficient.

<code>
0 0 1 0 0 0
1 0 0.9999 2 3 4
2 99 Si 0 0
3 99 Cr 0 0
</code>

If we use the database material (type = 99), we have two parameters more, that
can be used to force the system to use different values of attenuation coefficient and density than those
calculated from the Xraylib database. This is most usually not needed and can be left zero to get them from Xraylib.

A second option how to override the density of the material
is to use the following directive in the main parameter file:
<code>
OVERRIDE_XRAYLIB_DENSITY
index value
</code>
which uses the supplied density for the particular index, but calculates everything using Xraylib as usual based on this density.

Xraytrace documentation

User Tools

Site Tools

Page Tools